IKON WSW

From Lockwiki
Jump to navigationJump to search


IKON WSW



IKON WSW
IKON WSW keyway - FXE47518.jpg
Name IKON WSW
Manufacturer IKON
Lock Type Cylinder
Lock Design Pin-tumbler, Sidebar
Security Rating(s) EN 1303
Specifications
# of Components 6 pin-tumblers, 5 sliders
Component Type Pin-tumbler, Slider

The WSW is an EN 1303-rated pin-tumbler lock, with a wave-track and dimple key, made by the German company IKON.

Principles of operation

WSW internal components

The WSW key is bitted on the sides and edges of the blade and is reversible. The mark of inventor Bo Widén appears on the key bow. The key has a row of six dimple cuts along the narrow edge of the blade, matching six pin-tumbler stacks in the cylinder. There are three different heights for these key pins. They are T-shaped and rest in matching chambers drilled in the plug. The brass driver pins for this row of pins are a mix of three standard pins and three spool security pins.

The WSW also features one or two sidebars, depending on the model. The interior model has five side pin sliders with a single sidebar. The exterior model adds either two or five additional side pins connected to a second sidebar. The steel side pins are spring-biased and control the sidebar(s) of the lock.

To open the lock, all six key pins must be aligned at the shear line while all side pins are aligned with the sidebar. (See also Pin-tumbler, Principles of operation)

Disassembly instructions

The IKON WSW is disassembled much like other euro profile cylinders, with some care for the sidebar and side pins during disassembly.

The WSW has a multiple component cam piece that is disassembled before the plug can be removed. To access the cam components, rotate the cam until a hole in the side of the cam is revealed, and insert a tool to press the spring-biased retainer inside. At the same time, pry away the side plate of the cam. The inner two plates can then be removed, allowing the plug to slide through the cylinder housing.

A pinning shoe, used with a modified key, is a common method for removing the plug from a Euro profile cylinder. The plug is rotated 180 degrees either clockwise or counter-clockwise, and the pin retainer inserted into the edge of the keyway. This allows the plug to be removed while preventing the driver pins and springs from escaping the cylinder housing. As an alternative method, a segmented plug follower could be used.


Ratings


Gallery


See also


Stub lock.png
This article is a stub. You can help Lockwiki by expanding it.