MIWA JN

From Lockwiki
Revision as of 14:13, 2 February 2023 by Mgsecure (talk | contribs) (additional feature image)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

MIWA JN



MIWA JN
MIWA JN front keyway - FXE48203.png
Name MIWA JN
Manufacturer MIWA
Lock Type Cylinder
Lock Design Pin-tumbler, Dimple
Specifications
# of Components up to 21
Component Type Pin-tumbler
MIWA JN four pin axes

The JN is a dimple lock made by the Japanese manufacturer MIWA. Drilled for 21 pins, it is often filled with fewer active pins. Pins are arranged in four rows to the left side of the keyway, the right side and two diagonal rows milled 45 deg. from the bottom of lock.

Principles of operation

The MIWA JN utilizes dimple keys but functions the same as a standard pin-tumbler lock. The dimple key of the JN has four cut depths for the two rows of side pins and two, different cut depths for pins in the two diagonal rows. The key is bitted on the sides and edges of the blade and is reversible. To open the lock, all active pin-tumblers -- across all four rows of pins -- must be aligned at the shear line. (See also Pin-tumbler, Principles of operation).

The lock contains up 21 chambers for pin-tumbler stacks. At most, it is drilled for six pins in the right-hand side row of pins and five in each of the other rows. It is common for the lock to contain fewer than 21 pins. In that case the core, housing, and key may only be milled for the active pins. Each active chamber contains a set of key pin, driver, and spring.

MIWA utilizes a variety of security pins to deter picking. Active pin stacks incorporate six total lengths of stainless steel key pins with several sizes of steel and brass driver pins to match. The JN uses standard driver pins which are cupped to allow the spring to nest inside the pins. Key pins are a combination of t-pins and multi-section tapered spools which are torpedo shaped to create overset traps.

There is no counter- or over-milling in the core. The lock does not contain bearings for centering the core nor does it house any additional mechanisms for drill protection.

Disassembly instructions

Disassembly may vary by cylinder type. For the most common Japanese RIM cylinder the cylinder must first be removed from it's outer housing. It is kept in place by a single C-clip and positioned by washers in the outer housing. Care should be taken to preserve the order of these washers and internal components while disassembling.

The lock cylinder itself can be disassembled by removing the c-clip retaining the core and gutting the lock using a plug follower. Pins and springs can also be removed by sliding out each of the four bible covers holding them in the lock.


Gallery


See also


Stub lock.png
This article is a stub. You can help Lockwiki by expanding it.