FAB 1000: Difference between revisions

From Lockwiki
Jump to navigationJump to search
(categories)
(Added the patent.)
Line 7: Line 7:
| lock_type = [[Cylinder]]
| lock_type = [[Cylinder]]
| lock_design = [[Pin_tumbler|Pin-tumbler]]
| lock_design = [[Pin_tumbler|Pin-tumbler]]
| patent =  
| patent = CZ304946B6
| years_produced =  
| years_produced =  
| related =  
| related =  
Line 64: Line 64:
* [https://www.fab.cz/cs/site/fabcz/produkty/cylindricke-vlozky/fab1000/ FAB 1000 product page]
* [https://www.fab.cz/cs/site/fabcz/produkty/cylindricke-vlozky/fab1000/ FAB 1000 product page]
* [https://youtu.be/uaNwXQCORCkg FAB 1000 - Info, pick and gut]
* [https://youtu.be/uaNwXQCORCkg FAB 1000 - Info, pick and gut]
* [https://patentimages.storage.googleapis.com/11/ac/4c/83b875b4460aac/CZ304946B6.pdf CZ304946B6 patent (in Czech)]


[[Category:FAB]]
[[Category:FAB]]
[[Category:Lock models]]
[[Category:Lock models]]
[[Category:Pin-tumbler locks]]
[[Category:Pin-tumbler locks]]

Revision as of 19:57, 23 November 2021

FAB 1000

FAB 1000
FAB1000U4 least.png
Name FAB 1000
Manufacturer Fab
Lock Type Cylinder
Lock Design Pin-tumbler
Patent CZ304946B6


FAB 1000 is one of two locks in FAB's current portfolio belonging to a resistance class 4 (according to CSN P EN1627:2000), which is the highest resistance class FAB offers.


Description

The lock contains five pin stacks, with two chambers containing standard drivers, two chambers contain RBC pins and there is a single spool. This configuration hints that the manufacturer perceives dynamic methods as a higher threat than picking (although RBC pins can frustrate picking as well).

There are also positions for passive pins on the side of the core and the key features dimples on its right side that interact with those pins. It seems that normally marketed locks contain only one passive pin and the other position is populated by a ball bearing, which probably serves as additional anti-drill protection.

The profile used is quite paracentric and relatively thin, which adds to the protection against lockpicking. There is also considerable amount of anti-drill protection.

The key is protected with both patent application and utility model; the blanks are restricted and key can be cut or copied only when locksmith is presented with a security card.

Dissassembly instructions

To disassemble a double euro cylinder, use of a pinning shoe is the preferred method.

Other possibility is to use a segmented follower, but that requires that both cores are pulled out a bit to allow a cam removal. Then a core should be rotated to approximately 4:30 or 7:30 o'clock position (135 degrees either clockwise or anti-clockwise) to prevent driver entering a gaps for the cam clutch. Then a segmented follower can be used to remove the core.

Be careful to orient the whole lock in such a way, that the loss of passive pins is prevented (they are on the right side of the core, when the lock is situated in a pins down direction).

Vulnerabilities

The FAB 1000 is vulnerable to one or more of the following:

Gallery

References


See also