Back cutting: Difference between revisions

From Lockwiki
Jump to navigationJump to search
mNo edit summary
No edit summary
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
= Back Cutting =
= Back Cutting =


'''Back cutting''' describes a situation in which the slopes between the cuts on a [[Key|key]] are too steep, causing the key to become stuck in the [[Lock|lock]]. To remove the key, a broken key extractor may be used to attempt to lift components out of the way or the lock may be fully disassembled.
'''Back cutting''' describes a situation in which the slopes between the cuts on a [[Key|key]] are too steep, causing the key to become stuck in the [[Lock|lock]]. Back cutting can also happen when proper keying specifications are not followed, particularly [[MACS]] between components. To remove the key, a broken key extractor may be used to attempt to lift components out of the way or the lock may be fully disassembled.


To prevent back-cutting, key specifications should be followed, in particular the angle of slopes between key cuts.
To prevent back-cutting, key specifications should be followed, in particular the angle of slopes between key cuts.
Line 9: Line 9:
* [[Key]]
* [[Key]]
* [[Lock]]
* [[Lock]]
{{Stub}}


[[Category:Keys]]
[[Category:Keys]]

Latest revision as of 17:54, 12 February 2010

Back Cutting

Back cutting describes a situation in which the slopes between the cuts on a key are too steep, causing the key to become stuck in the lock. Back cutting can also happen when proper keying specifications are not followed, particularly MACS between components. To remove the key, a broken key extractor may be used to attempt to lift components out of the way or the lock may be fully disassembled.

To prevent back-cutting, key specifications should be followed, in particular the angle of slopes between key cuts.

See also


Stub lock.png
This article is a stub. You can help Lockwiki by expanding it.