ASSA d12

From Lockwiki
Revision as of 17:21, 5 September 2021 by Sandplum (talk | contribs) (added Stub tag)
Jump to navigationJump to search

ASSA d12

ASSA d12
Assa d12 front.jpg
Name ASSA d12
Manufacturer ASSA-Abloy
Lock Type Cylinder
Lock Design Pin-tumbler


The d12 is a medium security pin tumbler made by ASSA for residential or commercial use. It is intended as a successor to the ASSA 700 series which dates back to 1948. It features six pins and numerous security improvements over the original cylinder, including a paracentric keyway and patented key profiles.


Principles of operation

Add to me!

Disassembly instructions

There are two main assemblies this lock can be found in which will vary by branding and format. One uses a C-clip on the back on the plug while the other uses a large retaining screw.

If the lock uses the retaining screw:

  1. Unscrew the Torx screw on the tailpiece and remove the wafer beneath it.
  2. Unscrew the retaining screw from the rear of the plug.
  3. Unscrew and remove the closing rod over the pin chambers (be careful not to allow springs to escape).
  4. Remove the driver pins and springs. They are all the same so there is no need to keep them in order. Key pins cannot fit through the top chambers.
  5. Slide the plug out of the housing.

Disassembly using a follower is possible but not recommended due to the threads on the back of the plug that accept the retaining screw.


If the lock uses a C-clip:

  1. Remove the C-clip.
  2. Insert the key and turn the plug 45-90 degrees.
  3. Withdraw the plug from the cylinder. (A plug follower is recommended)

Vulnerabilities

The ASSA d12 may be vulnerable to one or more of the following:

Gallery

References


External links

See also


Stub lock.png
This article is a stub. You can help Lockwiki by expanding it.