FAB 50

From Lockwiki
Revision as of 20:28, 22 September 2021 by Least (talk | contribs) (FAB 50 page added)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

FAB 50

FAB 50
FAB50 least.png
Name FAB 50
Manufacturer Fab
Lock Type Cylinder
Lock Design Pin-tumbler


FAB 50 is the low end of FAB's portfolio; it belongs to a resistance class 1, which means it is meant to be used for temporarily locking objects without providing much security.


Description

The lock contains five pin stacks, with two chambers containing standard drivers, and three chambers contain spools. These spools, along with usually quite agresive bitting do provide some basic anti-picking protection. The profile used (R14) is not paracentric, and there is no anti-drill or anti-bumping protection.

Dissassembly instructions

To disassemble a double euro cylinder, use of a pinning shoe is the preferred method.

Other possibility is to use a segmented follower, but that requires that both cores are pulled out a bit to allow a cam removal. Then a core should be rotated to approximately 4:30 or 7:30 o'clock position (135 degrees either clockwise or anti-clockwise) to prevent driver entering a gaps for the cam clutch. Then a segmented follower can be used to remove the core.

Vulnerabilities

The FAB 50 is vulnerable to one or more of the following:

Gallery


References


See also